P1299 Autobianchi Stellina Engine Fault Code

Check Solution For P1299 Autobianchi Stellina OBD Code :

P1299 Autobianchi Stellina engine code seems a kind of powertrain problem, we try to show one by one the meaning and the solution.
Brief explanation of the P1299 Autobianchi Stellina code and definition of P1299 Autobianchi Stellina is the bottom side.

P1299 Autobianchi Stellina Meaning :

p Powertrain Code
Problem is related engine, transmission and emissions systems.
1 MFG - Manufacturer Specific
2 Accelerator Pedal Position (APP) Sensor 1 Performance
9 Crankshaft Position Sensor Circuit Performance
9 Kick-Down Switch Failed Short

MFG - Manufacturer Specific codes, which have a '1' as their second digit to indicate they are unique to a particular vehicle make or model. These special codes were deemed necessary by the vehicle manufacturers so they could provide additional diagnostic information beyond the basic list of generic OBD II codes for all kinds of faults, not just emissions-related faults.

How To Fix P1299 Autobianchi Stellina ?

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P1299 Autobianchi Stellina Code Description:

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the P1299 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools. When you see P1299 Autobianchi Stellina engine fault code on your engine code reader this description will help you.

P Codes List of all Powertrain codes.

Final Step: In the definitions listed below, there is a test drive recommended after you've completed any repairs to see if the condition is fixed. Before you take a test drive after a repair, always erase the P Code(s) first. This will turn the check engine light off and then you will know if the check engine light returns, you've got further diagnostics to complete.

BE CAREFUL !
This engine code information is presented for information purposes only. This is not intended as repair advice and we are not responsible for any actions you take on any vehicle.

About Us | Contact | Privacy

Copyright © 2016 - EngineFaultCode.com
All rights reserved.
Sitemap

Valid CSS!